Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Periodic flow condition
Posted Oct 27, 2014, 6:17 a.m. EDT Fluid & Heat, Studies & Solvers Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
I am confused about how to use the periodic flow condition. I have a long and repeated geometry, and I want to model just one section of it (since it is repeated anyway).
Geometry is very simple (laminar incompressible flow in a tube) but, how do I specify initial conditions at the inlet, number of iteration and where the outlet flow goes back into the inlet?
Thank you in advance
Hello Valentina Nappo
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam