Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

combining two geometries together

Please login with a confirmed email address before reporting spam

Hi,

I am trying to combine geometries. I have a square below which is a thin rectangle touching it through its top edge. The above square is given some pre displacement condition, I expect thin rectangle to get attached with it only through top right vertex and show some stress as at the bottom it is fixed. Which type of joint can best describe this situation? Please, help as I am new to Comsol Multiphysics.
I am using Solid Mechanics module to simulate this behavior.
Thanks.


0 Replies Last Post Feb 17, 2015, 6:10 p.m. EST
COMSOL Moderator

Hello Tanmay Bhargava

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.