Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Wrong number of dofs in property u: using the postprocessing commands

Please login with a confirmed email address before reporting spam

Hello,

I am using Matlab to model in Comsol Multiphysics. I have my model built, have run the meshextend function, and the solver femtime. However, when I proceed to plot the solution using 'postplot' or 'postcrossplot' I get the error message "wrong number of dofs in property u"

I think this has something to do with the compatibility of the current mesh and the plot, but I have no idea how to resolve this issue.

If you have any hints in this matter they would be greatly appreciated.

Thanks,
Chris

0 Replies Last Post Jun 16, 2010, 1:14 p.m. EDT
COMSOL Moderator

Hello Chris Nickell

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.