Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

changing material properties between load steps

Please login with a confirmed email address before reporting spam

All,

I would like to perform a simulation where I change the material property of a domain while using the solution from a previous run as an initial condition. Is this possible in Comsol?

Thanks in advance,
Y

0 Replies Last Post May 5, 2015, 2:04 p.m. EDT
COMSOL Moderator

Hello Yarom Polsky

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.