Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

normal stress and mohr-coulomb failure

Please login with a confirmed email address before reporting spam

Hello,

I would like to calculate friction failure along a surface of my axisymmetric model using Mohr-Coulomb (which parts fail and don't). The idea would be to plot a 1D plot of the surface where the stress reaches failure.

I need to use the normal stress to that surface to calculate tau (= cohesion + normal stress * tan theta), and I was wondering if COMSOL was providing the normal stress to each surface in other.

I also found that the normal stress is equal to
normal stress = 0.5*(sigma1 + sigma3) - 0.5*(sigma1 - sigma3)*cos(2theta)
where sigma1 = solid.sp3 and sigma3 = solid.sp1, does COMSOL provides theta the angle between the plane and sigma1 (=solid.sp3)?

Thank you for your help

0 Replies Last Post Jun 11, 2015, 11:20 p.m. EDT
COMSOL Moderator

Hello Erwan Chattel

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.