Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Memory error
Posted Jul 7, 2015, 12:25 p.m. EDT General, Geometry, Mesh, Structural Mechanics Version 5.1 2 Replies
Please login with a confirmed email address before reporting spam
I am getting the following error:
Failed to find a solution.
Unable to read or write out-of-core file.
Returned solution is not converged.
I am using an extra fine mesh, because I am modelling the stresses in microwells in a PDMS strip, and with a courser mesh the wells aren't defined.
Thanks.
Hello Valerie Bentivegna
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
this problem happens to me recently. I think, maybe it is the reason that the virtual memory is exhausted while calculation. Try to set virtual memory to a bigger disk and make it larger.
I am going to try this way, hoping I am lucky~~
Best regards
Xiaoqiu HE
Please login with a confirmed email address before reporting spam
Now I am totally sure that this problem is caused by the exhaustion of windows' virtual memory. Set window's virtual memory to a disk which has a large free space and re-run the model, then you would not meet that problem again.
Best regards
Xiaoqiu HE