Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulating induction from a wire to a coil

Please login with a confirmed email address before reporting spam

Hello community,

I am new to Comsol and try to make my first steps.
I want to simulate the induction of current from a live wire into a printed coil on a circuit board.
The coil is a few centimeters above that wire so it must be in 3d.
I added a picture to show what i mean.

Are there any tutorials that are similar to my problem?

Thank you for your help and suggestions!


1 Reply Last Post Aug 3, 2015, 2:26 p.m. EDT

Please login with a confirmed email address before reporting spam

Posted: 9 years ago Aug 3, 2015, 2:26 p.m. EDT
Help me, please!
Help me, please!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.