Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Comsol 3.5a

Posted Oct 25, 2015, 2:12 p.m. EDT 0 Replies

Vinay Sigedar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am using comsol 3.5a for designing bending insensitive photonic crystal fiber. I want to calculate the bending loss of the fiber. By reading on internet i found out that i have to set the PML boundary conditions so that the light gets confined at the imaginary part. So how to set the PML boundary conditions in comsol 3.5a. Please help me as i need to finish this project by december. And i got stuck on this. So please help me as early as possible.
0 Replies Last Post Oct 25, 2015, 2:12 p.m. EDT
COMSOL Moderator

Hello Vinay Sigedar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content