Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Failed to find consistent initial values in Copper Deposition model

Posted Oct 12, 2010, 6:10 a.m. EDT 2 Replies

sedtanann
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I just started to use comsol for simulation an electroplating process

and to understand the process I tried out Electrochemical Copper Deposition model

after i computed it shown as an attached file

then i see an error in the problem function that

Failed to find consistent initial values.
Singular matrix

could anyone explain about this?

Thank you very much,
Sedtanan

--
Pardon for my bad english

**i attach a file that i followed the step in pdf file on www.comsol.com/showroom/documentation/model/2112/ (ver 4.0) also thanks again

Attachments:

2 Replies Last Post Oct 18, 2010, 4:32 a.m. EDT
sedtanann
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Oct 18, 2010, 3:28 a.m. EDT
is there anybody know this

or any suggestion to get understand this error?


--
Pardon for my bad english
is there anybody know this or any suggestion to get understand this error? -- Pardon for my bad english
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Oct 18, 2010, 4:32 a.m. EDT
Hi

are you shure that when you impose two current sources and no drain that you have an equilibre in the current flow ?

Failed to find initial conditions is typically there when the BC's and model set-up is not coherent

--
Good luck
Ivar
Hi are you shure that when you impose two current sources and no drain that you have an equilibre in the current flow ? Failed to find initial conditions is typically there when the BC's and model set-up is not coherent -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content