Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

adding external circuit to already computed model

Posted Jul 2, 2016, 3:50 a.m. EDT 1 Reply

Vivek Kumar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
I am quite new to comsol,
I want to add an external voltage source and resistor to already modeled project www.comsol.co.in/model/modeling-a-spiral-inductor-coil-21271"
can you please tell me what are the steps for that?
regards,
vivek
1 Reply Last Post Jul 2, 2016, 10:28 a.m. EDT
Vivek Kumar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago Jul 2, 2016, 10:28 a.m. EDT
the executed model is given here
www.comsol.co.in/model/modeling-a-spiral-inductor-coil-21271
the executed model is given here https://www.comsol.co.in/model/modeling-a-spiral-inductor-coil-21271

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content