Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Error in On-state Capacitance value of MEMS capacitive switch
Posted Aug 31, 2016, 4:38 p.m. EDT MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Structural Mechanics Version 5.2 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I am simulating a MEMS capacitor. The pull-in voltage of the device is 1.5V. I used the stationary study to find out the C11(terminal capacitance) @ 1.5 V i.e. after the beam is pulled in. But the value of C11 displayed is wrong. I know theoretically it should be > 13 fF, but it is displaying 0.72 fF (which is the roughly its off-state value). I even followed an application example "rf-mems-switch" and obtained capacitance after applying step voltage (Transient study), but displayed the same wrong value. I don't know where I am going wrong. Is there any one who faced similar issue?.
I am simulating a MEMS capacitor. The pull-in voltage of the device is 1.5V. I used the stationary study to find out the C11(terminal capacitance) @ 1.5 V i.e. after the beam is pulled in. But the value of C11 displayed is wrong. I know theoretically it should be > 13 fF, but it is displaying 0.72 fF (which is the roughly its off-state value). I even followed an application example "rf-mems-switch" and obtained capacitance after applying step voltage (Transient study), but displayed the same wrong value. I don't know where I am going wrong. Is there any one who faced similar issue?.
1 Reply Last Post Sep 3, 2016, 3:16 p.m. EDT