Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

initial Value for electrolyte and electrode

Posted Sep 1, 2016, 12:42 p.m. EDT Battery Design Version 5.2a 0 Replies

Yuchen Wang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I want to ask question about initial Value for electrolyte and electrode. I read the manual, it is said that ''Use this node to specify the Initial Values of the electrolyte potential and the electric potential for the solver''. So setting up the initial value can just improve solver convergence, right? There is a time-dependent problem. The potential distribution of one domain changes with time because of boundary condition. Then I set up initial value 1V for this domain . Is that mean that the potential throughout this domain is 1V at t=0s? Or the potential distribution at t=0s is not related to initial value 1V, just to give a start point to get the convergence? The former or latter? Thank you so much
0 Replies Last Post Sep 1, 2016, 12:42 p.m. EDT
COMSOL Moderator

Hello Yuchen Wang

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content