Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modeling halbach permanent magnet array linear Syncronous motor

Please login with a confirmed email address before reporting spam

Hello,

I have modeled a linear motor as described in the subject in comsol 5.2 . I have tried steps that have been presented in "Modeling 2d Magnetic gear" and "Linear Tubular motor/generator" tutorials but there seems to be a problem. when I change the magnitude of currents in stator coils, No changes in magnitude of forces on
mover is observed (even when the current is zero you can see about 2400 N force is exerted to the mover!). In addition to that I have problem in defining air gap interface between mover and stator
that I think probably causes the problem I just mention before. I am using magnetic field and moving mesh physics.


I will be cordially grateful, if you could help.


0 Replies Last Post Oct 23, 2016, 3:27 a.m. EDT
COMSOL Moderator

Hello Behzad Namin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.