Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Parametric sweep to boundary mode analysis

Please login with a confirmed email address before reporting spam

Is there a way to send a list of parameters to a boundary mode analysis study step.

In a 2Dwaveguide simulation I have a boundary mode analysis step followed by frequency domain.
I can send a list of frequencies to the frequency step using parametric sweep but I can't find a way to send the same list of frequencies to the boundary mode analysis step.

Is this possible?

Thanks

0 Replies Last Post Nov 23, 2016, 2:41 p.m. EST
COMSOL Moderator

Hello Ciaran Phelan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.