Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Plot the full matrix of S-parameters using 2 ports on

Posted Feb 8, 2017, 8:51 a.m. EST RF & Microwave Engineering Version 5.1 1 Reply

Guillaume Laporte
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I'm working on a combiner from 2 to 1 using waveguide technology. I manually set port 1 and port 2 on then I simulated. However, I can not plot the S-parameters : S21, S31, … They are not even suggested in the choice list.

Is there a way to calculate the full matrix of S-parameters using 2 ports on ?

Thank you,
Guillaume
1 Reply Last Post Feb 8, 2017, 9:39 a.m. EST
Dave Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago Feb 8, 2017, 9:39 a.m. EST
> Is there a way to calculate the full matrix of S-parameters using 2 ports on ?

This can be done automatically using the "Activate port sweep" setting.

DWGreve
DWGreve Consulting
> Is there a way to calculate the full matrix of S-parameters using 2 ports on ? This can be done automatically using the "Activate port sweep" setting. DWGreve DWGreve Consulting

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content