Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How do I get the normalized output power of a directional coupler in COMSOL?

Posted Aug 4, 2017, 2:40 p.m. EDT RF & Microwave Engineering, Results & Visualization Version 5.0, Version 5.1, Version 5.2, Version 5.2a, Version 5.3 0 Replies

Elizete Sabino
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

My design is about a directional coupling. I put probes in the exit door to get the power, but I need it normalized. I put the expression

 mod1.PN=(mod1.ewfd.nPoav/(mod1.bnd1+mod1.bnd2))

Where PN is the normalized power the bnd1 and bnd 2 are the test points, are calculating the output power at ports 4 and 3 respectively

But yielded no result.

If someone can give me a suggestion I'm grateful.

Hello, How do I get the normalized output power of a.... Available from: www.researchgate.net/post/Hello_How_do_I_get_the_normalized_output_power_of_a_directional_coupler_in_COMSOL [accessed Aug 4, 2017].
0 Replies Last Post Aug 4, 2017, 2:40 p.m. EDT
COMSOL Moderator

Hello Elizete Sabino

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content