Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Please help: Low transmission of applied force

Posted Aug 17, 2017, 6:27 a.m. EDT 0 Replies

Iman
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,

I've been simulating a pliers for my thesis. While doing this, I encountered the problem that the applied force doesn't seem to be transmitted fully.
Even a very high applied force leads to quite low deformations of the object (while the Young's modulus of the pressed object is very low: ~3.3 MPa).

The COMSOL-file is attached and I would apperciate any help!
Thank you.

Best regards,
Iman

Attachments:

0 Replies Last Post Aug 17, 2017, 6:27 a.m. EDT
COMSOL Moderator

Hello Iman

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content