Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Updating Mesh for Topology Optimization

Posted Dec 14, 2017, 1:29 p.m. EST LiveLink for MATLAB, Optimization, Structural Mechanics Version 5.3 0 Replies

André Dinis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello!

I am trying to implement an algorithm using LiveLink for MATLAB in order to perform a topology optimization. In short, I want to "disable" elements that verify a certain condition (ex: Von Mises stress < XXX MPa). Is there any way to, in the mesh generation process, disable a specific element? If so, how do I update the model in order to use the new mesh?

Thank you in advance!

0 Replies Last Post Dec 14, 2017, 1:29 p.m. EST
COMSOL Moderator

Hello André Dinis

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content