Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

The problem of Permanent Magnet Motor in 3D

Please login with a confirmed email address before reporting spam

I built the case geometry(Permanent Magnet Motor in 3D) into a complete geometry and solved it. Can anyone tell me why it does not converge? thanks!

But if I change the condition of the permanent magnet from Ampere's law to flux conservation, it would converge. What is the reason?


1 Reply Last Post Dec 18, 2017, 5:39 a.m. EST

Please login with a confirmed email address before reporting spam

Posted: 7 years ago Dec 18, 2017, 5:39 a.m. EST

hi, Not Converging can have a lot of reasons. Maybe because of the solvers, the mesh, or your physic models.

Regards, Siqi

hi, Not Converging can have a lot of reasons. Maybe because of the solvers, the mesh, or your physic models. Regards, Siqi

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.