Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

copy mesh to a component in a higher dimension

Posted Dec 29, 2017, 7:26 a.m. EST Mesh Version 5.3 1 Reply

Vale R.
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I'm trying to copy the mesh created on a 2d surface (obtained from a cross section of my 3d model) to the same face in the 3d model and then extrude the mesh to all the domain. I'm trying to use the tool "Copy" to copy the mesh from the 2d surface to the source face in 3d, but I've not totally understand how to do it. I'm following the instruction found at this link (in italian):

https://www.comsol.it/release/5.1/mesh-and-geometry

I'm using Comsol 5.3

All the best, V.

1 Reply Last Post Dec 30, 2017, 7:01 p.m. EST
Jim Freels mechanical side of nuclear engineering, multiphysics analysis, COMSOL specialist
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago Dec 30, 2017, 7:01 p.m. EST

Provide your model, and we can take a look at it.

-------------------
James D. Freels, Ph.D., P.E.
Provide your model, and we can take a look at it.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content