Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Recording heat transfer coefficient

Posted Jan 26, 2018, 7:45 a.m. EST Structural & Acoustics, General, Heat Transfer & Phase Change 2 Replies

H KH
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everybody, I am doing some transient heat transfer simulation, including an air natural external convection/flux. The heat transfer coefficient, h [W/m^2/K], is calculated by COMSOL based on a given geometry. My simulation is going well, and the results are in good agreement with the experimental ones. But, I need to record the heat transfer coefficient, h [W/m^2/K] values adopted in the simulation by COMSOL. The variable h, assigned to the heat transfer coefficient according to the User Guide, refers to the element size in the software, not the heat transfer coefficient! I very much appreciate any guidance ... :)

2 Replies Last Post Apr 11, 2018, 4:56 a.m. EDT
H KH
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago Jan 26, 2018, 7:56 a.m. EST

I found it ...! ;)

I found it ...! ;)
PY
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago Apr 11, 2018, 4:56 a.m. EDT

Hi,

I have the same problem. What is the answer for this? :)

Hi, I have the same problem. What is the answer for this? :)

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content