Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Results for 3D Cut Line will not show for a specific domain

Please login with a confirmed email address before reporting spam

Hello all, I am running into an issue during post processing. I am trying to define a 3D cut line and plot the magnetic field strength as a function of position along that line. However, after the simulation runs, Comsol will not create a 3D cutline though a specific domain (in this case my substrate). I can create lines and plot results literally anywhere else, but not within that specific domain.

Has anyone run into this issue before? Any ideas on how to get the cut lines to work properly?

Thanks in advance! Sami

PS: I had to zip the comsol file. Its a bit over 5Mb even without the mesh or results.



0 Replies Last Post Apr 2, 2018, 12:15 p.m. EDT
COMSOL Moderator

Hello Sami Hawasli

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.