Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to rotate a 2D plot made based a general type plane

Posted Apr 18, 2018, 6:03 a.m. EDT Results & Visualization Version 5.3 1 Reply

Shuhan Chen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I build a 3D model with which I want to make a vertical plane and it is not parallel to x or y axis, so I made this plane with three points using general plane type. However, the 2D plots made with this plane has z axis horizontally, is there anyway to rotate these 2D plots?

Thanks,

Shuhan

1 Reply Last Post Apr 18, 2018, 8:11 a.m. EDT
Shuhan Chen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago Apr 18, 2018, 8:11 a.m. EDT

I've just figured out. It can be rotated by change the order of point 1,2,3 when creat the plane, the bottom left point should be point 1, and bottom right point should be point 2.

I've just figured out. It can be rotated by change the order of point 1,2,3 when creat the plane, the bottom left point should be point 1, and bottom right point should be point 2.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content