Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

A question about Livelink for matlab

Posted May 30, 2018, 4:00 p.m. EDT 2 Replies

kouri remi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I know that wa can create loops with matlab, and run a Comsol model in it so it can offer new possibilies for simulations. But can we create a loop where a boundary like an inflow Temperature is variable? It is to simulate the heating of a tank if the temperature is too low, and to stop the heating if the temperature is too high. Thank you

2 Replies Last Post May 30, 2018, 4:25 p.m. EDT
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 6 years ago May 30, 2018, 4:15 p.m. EDT

You may want to consider this approach instead:

https://www.comsol.com/blogs/implementing-a-thermostat-with-the-events-interface/

Jeff

-------------------
Jeff Hiller
You may want to consider this approach instead: https://www.comsol.com/blogs/implementing-a-thermostat-with-the-events-interface/ Jeff
kouri remi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago May 30, 2018, 4:25 p.m. EDT

I think this could do the job, thank you!

I think this could do the job, thank you!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content