Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Comsol stops the probe plot after 10,000 timestep?

Posted May 13, 2011, 6:32 p.m. EDT Results & Visualization, Studies & Solvers Version 4.1 1 Reply

Olivia Van
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Even a case is still running, it will not plot anymore. Is that true? and any way to increase the limit? Thanks,
1 Reply Last Post May 14, 2011, 3:14 a.m. EDT
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago May 14, 2011, 3:14 a.m. EDT
Hi

I have never managed to reach that limot ;) but perhps it's so, the best is that you contact support to hear what is the true limit ;)

--
Good luck
Ivar
Hi I have never managed to reach that limot ;) but perhps it's so, the best is that you contact support to hear what is the true limit ;) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content