Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Switching on parameters
Posted May 31, 2011, 8:30 a.m. EDT 1 Reply
Please login with a confirmed email address before reporting spam
Hi
I m using V3.5 and not familiar with MatLab. Can I use more than one parameter or boundary condition on a single comsol model. Let me give you an example: For Richards equation to solve for flow, I want to see the effect of Brooks and Corey parameters on the saturated water level by switching different values of alpha and n ( Say alpha = 6.5, 9.8, 33.3 ... and the corresponding n = 0,32, 0,208, 0,165 ......). Can I really make a simulation without MatLab and I don't want to setup different models for each cases. I just want to setup on a single model?
Thanks for your help in advance
I m using V3.5 and not familiar with MatLab. Can I use more than one parameter or boundary condition on a single comsol model. Let me give you an example: For Richards equation to solve for flow, I want to see the effect of Brooks and Corey parameters on the saturated water level by switching different values of alpha and n ( Say alpha = 6.5, 9.8, 33.3 ... and the corresponding n = 0,32, 0,208, 0,165 ......). Can I really make a simulation without MatLab and I don't want to setup different models for each cases. I just want to setup on a single model?
Thanks for your help in advance
1 Reply Last Post May 31, 2011, 11:08 a.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I believe so, for me it looks like a multi (=2) parametric sweep solving case
--
Good luck
Ivar
I believe so, for me it looks like a multi (=2) parametric sweep solving case
--
Good luck
Ivar