Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Why solution is different when using 1 or 3 Pressure Acoustics interfaces?
Posted Jan 19, 2019, 9:51 p.m. EST Acoustics & Vibrations Version 5.3 0 Replies
Please login with a confirmed email address before reporting spam
Hello everyone!
I'm working on a transient model consisting of one piezoelectric emitter transducer, one receiver and a cylindrical short sample. My first approach was to use one single Pressure Acoustics, Transient interface branch to obtain the acoustic pressure field of the entire model (emitter + sample + receiver). My second approach was to use 3 simultaneous Pressure Acoustics, Transient interface branches, one for each component, and connect them with appropriate Pressure and Impedance boundary conditions on the contact faces.
In the end, both methods provided different solutions. The first method (denoted as 1-P in the attached images) gave me a lossless periodic signal and the second method (denoted as 3-P in the attached images) gave me a periodic signal that asymptotically goes to zero as if I had inserted losses, which I didn't. Why both methods provide different solutions?
Attachments:
- 00_withAIR_simple_withPML_geometry.PNG
- 01_withAIR_simple_withPML_mesh.PNG
- 03_3-P_withPML_dof=6_dof-air=3_ddpFFT_f=0-750.PNG
- 03_1-P_withPML_dof=6_dof-air=3_ddpFFT_f=0-750.PNG
- 04_1-P_withPML_dof=6_dof-air=3_ddpXtime_t=0-500.PNG
- 02_withAIR_simple_withPML_mesh-zoom.PNG
- 04_3-P_withPML_dof=6_dof-air=3_ddpXtime_t=0-500.PNG
Hello Paulo Fernando Villafañe Garcia
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.