Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Calibration of element size in mesh size settings

Posted Sep 23, 2011, 2:09 p.m. EDT 0 Replies

Reza Sanaee
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi Folks,

I'm dealing with modeling fluid flow through a fractured model. whenever I'm using the fluid dynamics as my mesh size calibration the run will serve me with an error of out of memory due to factorization or calibration. Since my problem is a fluid dynamics one (Darcy law) it seems strange that the general physics calibration works better, Dosn't it?

Any comments on the logic of this calibration is greately appreciated. How one can be sure of its model mesh quality?

Cheers,
Reza
0 Replies Last Post Sep 23, 2011, 2:09 p.m. EDT
COMSOL Moderator

Hello Reza Sanaee

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content