Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Model geometry missing when using batch mode
Posted Oct 26, 2011, 3:47 a.m. EDT RF & Microwave Engineering, Geometry, Studies & Solvers Version 3.5a 2 Replies
Please login with a confirmed email address before reporting spam
I have calculated two of my comsol models using the batch mode. When opening the model the geometry tab is empty, however I can see the shape of the model in boundary and subdomain mode and also in the solution tab.
I assume that this problem is somehow connected with running Comsol in batch mode, because only then I see this behaviour.
I start the calculation with the folowing command line:
/usr/local/comsol35a/bin/comsol batch -np 8 -input modelname.mph
Maybe someone has already come across this problem and has a solution?
Thanks,
Clemens
Hello Clemens Schriever
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Anybody knows?
Please login with a confirmed email address before reporting spam
any ideas?