Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Non-zero stress and strain values for zero displacement with no preloading

Please login with a confirmed email address before reporting spam

Hi, I am trying to validate a compression test of hyperelastic material silicone. So I have taken a single cubical element of 1mm dimension and I have applied a prescribed displacement upto 0.5mm in compression. Now I am facing the following difficulties:

  1. The cube is bowing inwards rather than bulging outwards for the compressive loading. (Image attached) The response does not improve by meshing with multiple elements.
  2. There is non-zero stress (too high) and strin values for zero displacement of the element. (I am using auxiliary sweep) (See the probe table in the image)

I am using Ogden Model with N=2 for compressive test data.

I have been facing these high strain and stress values even for 2D simple models containg hyperelastic materials. One peculiarity is that the stretch value was correct but the strain was too high violating their relationship.

Can anyone please help me out with this?

Thanks.

compression.png


0 Replies Last Post Jun 21, 2019, 6:46 a.m. EDT
COMSOL Moderator

Hello Ankush Roy

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.