Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulataneously giving boundary load and body load

Please login with a confirmed email address before reporting spam

I want to give a boundary load and then a body load. More specifically, suppose I give initially a boundary load of 8N and then gave a body load for 10 secs. For this 10 sec I want to watch the velocity in the material for the body load given. Next I want to increase my boundary load to 10N nd again give a body load for 10 sec and watch the velocity. So this will continue with the boundary load as a parameter and for each boundary load given, I will give the same body load for 10 secs and watch the velocity. I have simulated the body load for 10 sec but not sure how to vary the boundary load as a parameter. Any help?


0 Replies Last Post Apr 24, 2020, 11:42 p.m. EDT
COMSOL Moderator

Hello Soumya Goswami

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.