Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Induction heating, Solver gets stuck in middle. Does not converge. Can someone help me please?

Please login with a confirmed email address before reporting spam

Hello I am trying to Induction heating and basically I gave a coil which is straight with a current applied to the coil to heat up a tool below. But the solver does not converge. I have attached the following image below. Does anyone have an idea how to deal with this problem? please help me.



0 Replies Last Post Apr 29, 2020, 6:18 p.m. EDT
COMSOL Moderator

Hello Vishal Rajasekaran

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.