Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Frequency modal analysis coupled with electric circuit interface get zero output
Posted May 5, 2020, 1:22 p.m. EDT Electromagnetics, MEMS & Nanotechnology 0 Replies
Please login with a confirmed email address before reporting spam
I tried to simulate a piezoelectric energy harvester using frequency modal analysis. If I disabled the electric circuit physics, I can calculate the average of electrical potential at the boundary of the electrode which I considered to be the EMF of the piezoelectric device. The value seems reasonable. After I enable the electrical circuit with a resistor and voltage from terminal from electricstatics physics, the voltage across the resistor I get is 0, and when I calculate the average of the electrical potential at the same electrode boundary, werid value is seen. Can someone help me understand this?
Hello Ceez Ben
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.