Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Electroosmotic velocity flow profile
Posted May 13, 2020, 11:47 a.m. EDT Electromagnetics, Low-Frequency Electromagnetics, Fluid & Heat 0 Replies
Please login with a confirmed email address before reporting spam
Hello,
Please I am a beginner with COMSOL and I am trying to simulate electroosmotic fluid flow in a channel inrder to capture the plug flow velocity profile. I have used the creeping flow, electric current and transport of diluted species physics to do this. I have modelled the electroosmotic flow such that the walls of the channel is subjected to an electroosmotic slip velocity. For the boundary conditions in my creeping flow physics, I have used the same inlet and outlet pressure (101325 Pa) for both and suspected that there could be a pressure build up somwhere in the channel due to the imposed boundary conditions. My simulation results keep giving me a parabolic flow profile instead of the expected plug flow profile even after changing the inlet and outlet pressures.
Please does anyone have any idea on how I can go about this?
Hello Benedicta Nwani
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.