Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Saving accumulated probe table at time steps taken by solver?
Posted Aug 7, 2020, 8:36 a.m. EDT Simulation Apps, Results & Visualization, Studies & Solvers Version 5.5 1 Reply
Please login with a confirmed email address before reporting spam
I am doing a parametric sweep on my studies and am interested in the results recorded by a few probes. When running without the sweep, I select to update probe results at the times taken by the solver; however that probe table gets overwritten at every iteration of the sweep. Accumulated table instead only saves the probe results at times stored at output. To get higher resolution, I have to increase the number of time steps of the output, which hugely increases my model size as it saves everything at that resolution.
Is there a way of outputing the accumulated probe table at times taken by the solver instead?
Hello Rapolas Daugintis
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Dear Rapolas,
I am facing the same problem. Did you manage to find a solution?
Thank you very much
Daniele