Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
2D axisymmetric / 3D meshing
Posted Mar 10, 2012, 10:52 a.m. EST Geometry, Mesh Version 4.2a 0 Replies
Please login with a confirmed email address before reporting spam
I am trying to do a simple simulation, inspired by your water glass www.comsol.com/showroom/gallery/195/ , to try and learn how to use COMSOL.
I am currently modeling a 2D axisymmetric closed cylinder of water, where the upper and under cap are subjected to a constant temperature differential, and the lateral area is insulated.
When trying to mesh, I set the mesh as delaunay triangulation, and it fills the cylinder nicely. I can produce an image of the mesh, superimposed over the temperature field, in a time dependent study, as a vertical slice.
However, I would like to have a better understanding on how COMSOL does the meshing and on how it meshes the rest of the cylinder. Specifically, how is the mesh created when seen from a horizontal slice, and how does the solution obtained from a 3D setup differ from one coming from a 2D asymmetrical setup.
Thank you for your time
Hello fhtagn
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.