Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Load groups in comsol

Posted Sep 10, 2020, 9:55 a.m. EDT Version 5.5 1 Reply

Zeus
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I want to study the response of different load cases in my model. I have defined three load groups but it seems as all my loads are in all of the load groups even if I select some of the loads and assign them to a specific group.

Morover, how do I study the response of a certain load group?

1 Reply Last Post Sep 10, 2020, 10:06 a.m. EDT
Zeus
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago Sep 10, 2020, 10:06 a.m. EDT
Updated: 4 years ago Sep 10, 2020, 12:35 p.m. EDT

Nevermind, found a solution. To however this may concern, here is a link to a comsol example of using load and contrain groups, and also how to activate them:

https://www.comsol.com/model/tapered-cantilever-with-two-load-cases-12681

Nevermind, found a solution. To however this may concern, here is a link to a comsol example of using load and contrain groups, and also how to activate them:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content