Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

simulation of vibration fatigue

Posted Sep 25, 2020, 10:34 a.m. EDT 1 Reply

晓辉 杨
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello dear all

I want to simulate the fatigue under sine acceleration. So before the setting of vibration fatigue, which former simulation should i do? frequency domain ,time dependent or stationary study? And then what should be setted in the vibration fatigue? Comsol informed me "The load cycle is not frequency controlled." How can i add the frequency to the load directly?

thank you for your attention!

Best regards Xiaohui

1 Reply Last Post Sep 26, 2020, 2:23 a.m. EDT
T Y
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago Sep 26, 2020, 2:23 a.m. EDT

Dear Xiaohui,

Are you passing the study into the fatigue module? As in you could run a stationary and use the intiial values for the fatigue module and set your break down criterion such as S-N curve etc.

Regards, TY

Dear Xiaohui, Are you passing the study into the fatigue module? As in you could run a stationary and use the intiial values for the fatigue module and set your break down criterion such as S-N curve etc. Regards, TY

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content