Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Circles with a mapped mesh
Posted Dec 17, 2020, 11:49 a.m. EST Mesh Version 5.5 0 Replies
Please login with a confirmed email address before reporting spam
Hi,
I have a heat transfer model where I need to make the mesh more efficient. Attached are two pictures. The first is my current mesh and the second is a picture from the forum that reprecents my goal. I have a 3d model where I first make a boundary mesh and then sweep that along the Z-axis.
In my model i have two concentric circles with a point in the middle in my boundary mesh: * The smaller circle should be meshed as coarcely as possible. * The bigger circle should be fine near the smaller circle and increasingly coarse along the radius. * Also the bigger circle should be coarse in the angle direction. I wish to mesh the circles with a mapped mesh like in the attached picture but can't figure out how to do that.
How do I replace the triangular meshes inside the circles with mapped meshes so that they get mapped along the radius?
Attachments:
Hello Atte Nieminen
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.