Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

SAW device 2D simulation

Please login with a confirmed email address before reporting spam

Hi,

I am doing a simulation of a SAW device for acoustophoresis. It is a 2D simulation and the device is seen from the top. The piezo is YZ LiNbO3, the PDMS structure is in the middle of the device and the fluid that flows in the channel is water.

With the parameters used, I have to find 3 pressure nodes in the channel (one in the middle and two on the sides of the channel), but I am not to obtain that and the distribution of the acoustic pressure is irregular. I don't know which are the errors, the file is uploaded.



0 Replies Last Post Feb 25, 2021, 10:27 a.m. EST
COMSOL Moderator

Hello Luigi Agazzi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.