Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

two values at a single node

Posted Apr 27, 2012, 8:27 p.m. EDT Fluid & Heat, Studies & Solvers Version 4.2a 0 Replies

Sirisha Govindaraju
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have an FSI model.
When I try to output the WSS on a particular edge, I notice that there are atleast 20 points where I have two values for WSS i.e., at each of these 20 points, there are two values for WSS.

I am not sure why this is happening. It looks like COMSOL is counting each point twice and I cannot understand why its happening. I am using the union option to create the geometry. So at two intersecting edges, only one point should be accounted for.

I appreciate if someone can clarify what's going on.

Thanks,
Sirisha
0 Replies Last Post Apr 27, 2012, 8:27 p.m. EDT
COMSOL Moderator

Hello Sirisha Govindaraju

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content