Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stopped-flow injection for 3D reactive transport modeling

Posted Mar 14, 2021, 1:15 a.m. EST Porous Media Flow 0 Replies

Oliver Ramos
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am doing a single-phase reactive transport model. I would like to ask if it is possible to have alternating flow and no-flow from an injection point (e.g. 1hr of flow, then 1hr of no-flow, and 1hr of flow again)? Also, is it possible to create one injection point in a 3D porous media (i.e. injecting fluid from an injection pipe at the center of the surface boundary of a 3D porous media, there is no flow except from the injection point)?

Thank you.

Oliver

0 Replies Last Post Mar 14, 2021, 1:15 a.m. EST
COMSOL Moderator

Hello Oliver Ramos

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content