Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

use input data for simulation from a previuso model result

Please login with a confirmed email address before reporting spam

Hi everyone, I want to study the stress field due to the application of load on a cavity. I did this modelling in a stationary mode and it is fine. Now, I would like to see the stress field over time, but I want to apply the load condition only at t=0 and see the effect on the strees over time, so for t=0+ until t=365 days, without having the boundary condition applied to the boundaries/edge for the duration of my modelling.

I was thinking to use the result of the stationary model as an input for the time-dependent study. My question is if is possible in comsol by having two studies: study 1 = stationary and study 2 = time dependend and in the latter specify the input data from the first one.

I tried to explore the Study options given but I am not sure I am heading in the right direction. Has somebody some suggest? Or some documentation for me to consult?

Thanks for the help, Chiara


0 Replies Last Post Jun 3, 2021, 9:28 a.m. EDT
COMSOL Moderator

Hello Chiara Lanzi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.