Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Different geometries in a single model

Posted Jun 21, 2021, 8:47 a.m. EDT Geometry Version 5.2 2 Replies

Kanupriya Varshney
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Can we make a portion of Geometry in 3D & another portion in 2D in same comsol file?

2 Replies Last Post Jun 22, 2021, 3:40 a.m. EDT
Dave Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 3 years ago Jun 21, 2021, 12:22 p.m. EDT

I have coupled a 2D simulation in one component with a 3D simulation in another. Is that what you have in mind?

If so the answer is yes.

I have coupled a 2D simulation in one component with a 3D simulation in another. Is that what you have in mind? If so the answer is yes.
Kanupriya Varshney
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 3 years ago Jun 22, 2021, 3:40 a.m. EDT

I have coupled a 2D simulation in one component with a 3D simulation in another. Is that what you have in mind?

If so the answer is yes.

Thankyou for the reply. Please help me how to do that in single comsol model.

>I have coupled a 2D simulation in one component with a 3D simulation in another. Is that what you have in mind? > >If so the answer is yes. Thankyou for the reply. Please help me how to do that in single comsol model.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content