Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Ports in planar transmission lines (RF Module in 4.2a)
Posted Jun 8, 2012, 2:06 p.m. EDT RF & Microwave Engineering Version 4.2a 0 Replies
Please login with a confirmed email address before reporting spam
Are there any guidelines to excite planar structures (i.e. microstrip lines, coplanar waveguides) through ports that are not lumped?
The example that would help me the best would be the Branch-line coupler example, but this one uses lumped ports to feed the structure.
As in the real world, waveports for planar structures are useful because one can directly define the input power, as opposed to figuring our diffuse concepts such as figuring out the required voltage/current for a given input power and perform modal analysis for complex structures such as grounded coplanar lines.
Thank you in advance for your help!
P.S. As an advice for the COMSOL manual/tutorial makers, besides giving examples of complex microwave structures, giving examples of *simple* popular planar transmission line structures such as microstrip, coplanar, grounded coplanar, stripline, etc. would *greatly* help to capture the concept for COMSOL RF simulations.
Doing it so for cases where Ports and Lumped Ports are used would save time for everyone, as feeding the RF model and defining boundaries correctly is usually the more challenging part of modeling...
Thanks!
Hello Carlos Donado
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.