Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Deactivating Liquid Phase

Posted Nov 1, 2021, 7:15 a.m. EDT Structural & Acoustics, Fluid & Heat, Heat Transfer 0 Replies

Aswin P
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I was trying to model a scenario where a heat source is moving on a boundary, incorpoarting 'Phase change Material'. A part of material is melted and the fraction of liquid phase shall be figured out. However the liquid phase converts back to solid phase due to transient heat loss. Is there any feasible tricks to keep the liquid phase as it is ? How to deactivate the points which crosses the melting point?

0 Replies Last Post Nov 1, 2021, 7:15 a.m. EDT
COMSOL Moderator

Hello Aswin P

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content