Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Extracting Data for parameter sweep using LiveLink for MATLAB

Posted Jul 26, 2022, 1:31 a.m. EDT LiveLink for MATLAB, Results & Visualization, Structural Mechanics Version 6.0 0 Replies

Shyam Kishor
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I performed a parametric study in a model in COMSOL-6. There are a lot of parameters in my parametric study using all combinations (almost 200 total combinations). The study is successfully done. Now in post-processing, I want to use LiveLink for MATLAB to analyze a specific result for each combination and want to automate it. I tried many times using the instruction given in the reference manual but failed. It will be helpful if you suggest any suggestions. Can I do it using LiveLink for MATLAB?

Thanks for your suggestions! Shyam

0 Replies Last Post Jul 26, 2022, 1:31 a.m. EDT
COMSOL Moderator

Hello Shyam Kishor

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content