Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how to do Initial setup in COMSOL for multi-phase flow using level set method

Posted Feb 11, 2010, 11:02 a.m. EST 2 Replies

Rongpei Shi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am simulating free surface problem (gas-water system) using level set method.

I have no idea to set up the Initial setup to get a good initial value to for phi.

Any suggestions?

Many thanks in advance!
2 Replies Last Post Feb 26, 2010, 6:14 p.m. EST
Sima Didari
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Feb 26, 2010, 6:14 p.m. EST
Hi
I think It is relate what you are modeling, what is ur domain?
Hi I think It is relate what you are modeling, what is ur domain?
Sima Didari
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Feb 26, 2010, 6:14 p.m. EST
Hi
I think It is relate what you are modeling, what is ur domain?
Hi I think It is relate what you are modeling, what is ur domain?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content