Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to add parallel light source to radiative heat transfer model
Posted Mar 2, 2023, 9:39 p.m. EST Ray Optics, Heat Transfer, Physics Interfaces 0 Replies
Please login with a confirmed email address before reporting spam
Hi， I simulated the conductive and radiative coupled heat transfer process when the sample was heated by laser (parallel light source) in a closed cavity. Surface-to-surface radiation was adopted, and the laser incident through a hole in the cavity boundary. I tried the Prescribed Radiosity in the surface-to-surface radiation interface, but I found that it could only set the diffuse emission light source instead of parallel light. How should I set the boundary conditions of the parallel light source? Or do I need to use The Radiation in Absorbing-Scattering Media Interface or The Ray Heating Interface? Best regards Shuai Wang
Hello Shuai Wang
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.