Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Problem with the Pulse Heat
Posted May 31, 2023, 8:22 a.m. EDT 0 Replies
Please login with a confirmed email address before reporting spam
Hi!
I am modeling a problem in 3D by shooting a thin copper sample with a laser beam in a circular spot with pulses. I can set the pulses to start, but I can't set them to stop and let the program run for a few more seconds. I need help with this so that, for example, the pulse shots on the surface run for 20 milliseconds, but let's say the program runs for 40 seconds, where can I set this?
My other problem would be the evaluation in 3D. I want to read from the 3D model how far a shot goes into the sample (um), but I can't increase the grid axis to see it more precisely. Is it possible to increase it somehow so that the grid axis is denser?
Best regards, Marton Soha
Hello Márton Soha
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.